OPTIMALISASI KESEIMBANGAN LINTASAN PRODUKSI DENGAN METODE LARGEST CANDIDATE RULE DI PT. PAP
Abstract
Research on the optimization of the balance of the production line was conducted at PT. PAP, which is a manufacturing company in the tire retreading industry. The not yet optimal production line has the potential to cause bottlenecks on the production line. The existence of workload imbalance can be seen from the significant variation in idle time from each work station. For this reason, this study was conducted with the aim of optimizing the line balancing which refers to indicators such as: balance delay, line efficiency and total idle time. The method used in this study is the Largest Candidate Rule (LCR) method which is part of the heuristic method. The use of heuristic methods is basically designed to get better results based on certain limitations. From the research results obtained: Balance Delay (D) = 25.05%, Line Efficiency (LE) = 74.95%, and the total idle time is 1.515 seconds. When compared with the initial state before optimization, the results are a decrease in Balance Delay (D) of 28.44%, an increase in Line Efficiency (LE) of 28.44%, and a reduction in total idle time of 3,699 seconds.
Downloads
References
[2] Gaspersz, V. (2002). Production Planning and Inventory Control. Jakarta: Gramedia Pustaka Utama.
[3] Ginting, R. (2007). Sistem Produksi. Yogyakarta: GRAHA ILMU.
[4] Hengky K. Salim, K. S. (2016, Januari). Perancangan Keseimbangan Lintasan Produksi Menggunakan Pendekatan Simulasi dan Metode Ranked Positional Weights. Jurnal Teknik Industri, Vol. IX No. 1, 53-60.
[5] Heizer, J. & Barry Render (2010). Operations Management (Edisi 9). Jakarta: Salemba Empat.
[6] Heizer, J., & Munson, B. R. (2017). Principles of Operations Management. Harlow Essex, England: Pearson Education Limited.
[7] Immawan, T., & Kurniawan, R. (2016). Analysis of Line Balance Sound Board Glue Production on
Assembly Grand Piano Process. Springer International Publishing. Switzerland, 349-359.
[8] Indiyanto, R. (2008). Perencanaan dan Pengendalian Produksi. Surabaya: Yayasan Humaniora.
[9] Kusuma, H. (2004). Manajemen Produksi. Yogyakarta: ANDI.
[10] Mateo, J. R. (2015). Management Science, Operations Research and Project Management. Farnham Surrey, England: Gower Publishing Limited.
[11] Munyai, T., Mbonyane, B., & Mbohwa, C. (2018). Productivity Improvement in Manufacturing SMEs. Boca Raton: CRC Press.
[12] Rachman, T., & Santoso., C. A. (2019). Penerapan Metode Heuristik Line Balancing Untuk Penentuan Keseimbangan Lintasan Optimal Pada Produksi Sampel Sepatu di PT. PBI. Jakarta: Universitas Esa Unggul.
[13] Rebentisch, E. S. (2017). Integrating Program Management and Systems Engineering. New Jersey: John Wiley & Sons, Inc.
[14] Roy, D. &. (2010). AssemblyLline Balancing to Minimize Balancing Loss and System Loss. Journal Industrial Engineering International, 6 (11): 1-5.
[15] Stevenson, W. J. (2018). Operations Management (Thirteenth Edition). New York: McGraw-Hill
