OPTIMASI KINERJA TURBIN PELTON RESPON KEMIRINGAN BUCKET DENGAN DIAMETER NOSEL MENGGUNAKAN SOFTWARE STATISTIKA
Abstract
Pelton turbine is a type of impulse turbine that converts all water energy into velocity energy before entering the turbine runner. The power generated in the water turbine (Pelton turbine) varies depending on the flow or flow of incoming water to turn the turbine.This research was conducted in the mechanical engineering laboratory of the Faculty of Mechanical Engineering, Universitas Harapan Medan. The experimental method is the method used in this study. Pelton Turbine performance optimization of bucket slope response and nozzle diameter using statistical software. Based on the results of the Pelton Turbine Testing Graph using the Taguchi method, the response of the bucket slope with the Maximum Rotation nozzle diameter, namely at -8º Bucket slope, produces a turbine rotation of 416.7 Rpm with a nozzle diameter of 19 mm. while with maximum power, the bucket tilt of 8º produces a turbine load of 405 watts with a diameter of 19 mm.
Downloads
References
[2] Irawan,H., Syamsuri, and Rahmad, “Analisis Performansi Sistem Pembangkit Listrik Tenaga Air Jenis Turbin Pelton Dengan Variasi Bukaan Katup Dan Beban Lampu Menggunakan Inverter,” J. Has. Penelit. LPPM Untag Surabaya, vol. 03, no. 01, pp. 27–31, 2018.
[3] Lubis,A., “Energi terbarukan dalam pembangunan berkelanjutan,” J. Tek. Lingkung., vol. 8, no. 2, pp. 155–162, 2007.
[4] Jember,U. and F. Teknik, “Makalah turbin pelton “,” 2017.
[5] Septiadi,R., “Optimasi Design Turbin Pelton Menggunakan 3 Nozzle Dan Varian Kemiringan Sudu Hingga 150 Menggunakan Metode Taguchi,”Teknobi= j Ilm. Progr.Stud.Magister Tek. Mesin, Vol.9, no.1 , pp.13-18, Feb.2019, doi :10.35814/ teknobiz.v9i1.885.
[5] B. A. B. Ii, “LANDASAN TEORI Pengertian Turbin Air Turbin air adalah alat untuk mengubah energi potensial air menjadi menjadi energi mekanik . Energi mekanik ini kemudian diubah menjadi energi listrik oleh generator . Turbin air dikembangkan pada abad 19 dan digunakan .”
[6] P.A., Pltmh, “Ii. tinjauan pustaka.”
Prapti,C. “Analisa Turbin Pelton Berskala Mikro Pada Pembuatan Instalasi Uji Laboratorium.”
[7] Abdulkadir, M. 2018. “PENGARUH SUDUT KEMIRINGAN TERHADAP KINERJA TURBIN ULIR.” KURVATEK 2(1): 65–72. https://journal.itny.ac.id/index.php/ krvtk/article/view/555.
[9] L. B. Masalah, “Universitas Sumatera Utara 1,” pp. 1–12, 1993.
[10] Juhrodin, Udin. 2013. Analisis Data Menggunakan Minitab 16.
[11] SmartStat. 2010. Mengenal Boxplot and Whisker Plot.
[12]Ishak,Aulia.2002,Rekayasa kualitas.Universitas Sumatera Utara, 2: 1-24
[13] Wahjudi,Didik dan Pramono, yohan. 2001.optimasi proses injeksi dengan metode Taguchi.(online): (http://www.puslit.petra.ac.id)
[14] Roy,Ranjit k.1990. A Primer on The Taguchy Method. New york: Van Nostrand Reinhold
