RANCANG BANGUN PEMANAS INDUKSI LOW POWER BERBASIS MIKROKONTROLER
Abstract
Induction Heating is one kind of heating that uses an induction principle. Induction heating is thought to be safer than conventional Heater due to it not depending on external heating source. The aim of this research is to understand the mechanism of controlling frequency in the heating system and Its effect on the performance of the system. From calculation and measurement, the maximum increase of temperature of 6.8°C is obtained at freqeuncy of 10 Hz in 600 s. The Maximum average heating value was measured at 1 kHz. This heating system also had a low consumption power of 48.677 watt. Nevertheless, this system had a temperature reading error of 9.83%.
Downloads
References
[2] Mulyatno. (2014). Fisika Umum II. Jakarta: Universitas Terbuka.
[3] Mustoffa, N., Rokhim, I., & Purnomo, W. (2012). Perancangan dan Pembuatan Sistem Pemanas Induksi untuk Bearing Berbasis Mikrokontroler Arduino UNO. Politeknik Manufaktur Negeri Bandung.
[4] Noviansyah, R. (2006). Pemanas Induksi (Induction Heating) Kapasitas 200 Watt.
[5] Setyawan, L. B., Susilo, D., & Wicaksono, A. V. (2015). Pemanas Listrik Menggunakan Prinsip Induksi Elektromagnetik. Techne Jurnal Ilmiah Elektroteknika, 89-94.
[6] Zulkarnaen, Y. (2013). Perancangan dan Pembuatan Pemanas Induksi dengan Metode Pancake Coil Berbasis Mikrokontroler ATMega 8535. Jurnal Mahasiswa TEUB, 1-6.